51/1173

This is a wrought iron rushlight holder with an turned oak base. One jaw is counterweighted to hold the rush in place, and ends in a small saucer to which it is likely that a candle holder was attached. Rushlights became extremely common after 1709 with the introduction of a tax on candles, which lasted until 1831. Rushes were peeled and the pith was weathered and immersed in hot bacon fat and left to dry, before being burned.

1 rushlight holder: metal (wrought iron); wood (oak); fair condition- woodworm

MERL 'Catalogue index' card – 'This holder is made of wrought iron with a decorated oak base. The end of the moving jaw is in the form of a small saucer and presumably had a candle holder attached to it which has been lost. The holes by which it was screwed are, however, visible. The holder is 8.8 inches high. // See also 51/1184.', MERL 'Catalogue index' card – 51/1184 – 'Rushlights were made from the common soft rush, “juncus effusus”. The rushes were peeled, apart from a narrow strip running the length of the rush, which served to hold the pith together. After a certain amount of weathering the pith was immersed in hot bacon fat or some other suitable substance and then placed on a sheet of bark to dry. // Gilbert White in the “Natural History of Selbourne” describes the whole process of rush light making in a letter dated 1775. He mentions that there may be upwards of 1600 rush lights to the pound and that one rush costs about one eleventh of a penny to make. Rushes were normally about 12 inches long and one of this length would burn for about half an hour. // The use of the rush light became extremely common after the introduction of the tax on candles in 1709. This tax remained in force until 1831. Most rushlight holders, therefore, date from the 18th and early 19th centuries., Victoria & Albert Museum No. 462, 1905.

1700-01-01 - 1799-12-31

Eighteenth century

Wood, oak, Metal, iron